Filter
Top Products
7
CONTINUOUS MODE
Continuous Mode function lets you remove the key from the ignition while leaving the engine running. This convenient
feature allows you to leave your vehicle for short periods while climate controls remain on.
AUTOMATIC
TRANSMISSION
VEHICLES
To access Continuous Mode, send Start command while engine is idling (see STARTING THE ENGINE on
page 6). Parking lights, engine and preset accessories will remain on for the duration of the
programmed runtime.
Remove the key, exit vehicle and lock all doors. All safety devices will remain active.
If you return to your vehicle before runtime has elapsed, just turn the key to RUN position and press the brake pedal.
WHAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
Your key is in the RUN position (prevents Start cycle).
Remote control sends a Stop message.
Hood is open.
Brakes are applied.
Engine is over-revving (if programmed Enable at installation).
Alarm detects intrusion.
Main switch is OFF.
Safety sequence not valid (manual transmission vehicle only - parking brake not applied, opening of door detected
while remote starter was not keeping engine running).
MAIN SWITCH
Main switch is usually mounted under dashboard. It is a toggle ON/OFF
switch that is used to cancel start functions.
It does not disable other commands which remain active (alarm, lock/unlock
commands, etc.).
STOP
When engine is kept running by Remote Starter, you can stop it with this
command (lights: 1).
The Stop command also ends panic mode and alarm condition without disarming the security system.