AstroStart 1105U Remote Starter User Manual


 
5
TABLE OF COMMANDS
CONFIRMATIONS
COMMANDS BUTTONS
H
ORN
P
ARKING
LIGHTS
S
IREN*
PANIC (6-BUTTON REMOTE)
30 / 60
SEC.
START / CONTINUOUS MODE
1 1 -
STOP
- 1 -
LOCK / ARMING*
1 1 / 3
1 / 3 / X

UNLOCK / DISARMING*
- 2 / 4 ¡
2 / 4 / X
¡
TRUNK
- 3 3
ACTIVATE / DEACTIVATE SENTINEL MODE
- 4 / 2 / 3 ¢ -
ACTIVATE / DEACTIVATE UTILITY 1
- 1 -
ACTIVATE / DEACTIVATE UTILITY 2
- 1 -
ACTIVATE / DEACTIVATE UTILITY 3
- 1 -
ACTIVATE / DEACTIVATE UTILITY 4
- 1 -
VALET MODE ACTIVATE / DEACTIVATE
- 4 / 2 ¢ -
RUNTIME SETTING
- 1 – 4 -
START TEMPERATURE SETTING
- 1 - 4 -
CAR FINDER
7 3 -
DISPLAY REMOTE START FAIL CODES
- 1 - 20 -
DISPLAY ALARM CONDITION CODES
- 1 - 8 -
* COMMAND RELATED TO ARMING AND DISARMING ONLY APPLIES TO MODEL 3106U ONLY.
THIS CONFIRMATION IS SENT ONLY WHEN COMMAND IS REPEATED WHILE ENGINE IS ALREADY RUNNING.
THIS COMMAND ENDS: RUNTIME, ALARM CONDITION AND PANIC MODE
CONFIRMATION BY CHIRP OR HORN ON 2
ND
LOCK (WHEN PROGRAMMED "ON"). HORN IS USED FOR CONFIRMATIONS OF 2
ND
LOCK
WHEN CHIRP FUNCTION IS DEACTIVATED.
ONLY IF SYSTEM IS EQUIPPED WITH A SENSOR, WHICH DETECTS WHEN TRUNK IS OPEN (OPTIONAL).
THESE CONFIRMATIONS ARE PROGRAMMABLE ENABLE/DISABLE DURING INSTALLATION.
1 = NO ZONE IS IN VIOLATION AT ARMING. 3 = AT LEAST ONE ZONE IS IN VIOLATION AT ARMING.
X = NO CHIRP WHEN VALET MODE IS ACTIVE OR WHEN ALARM IS PROGRAMMED "OFF".
TEMPORARY VALET MODE IS DISABLED IF COMMAND IS REPEATED DURING REARMING CYCLE.
¡
2 = NO ZONE WAS IN VIOLATION WHEN ALARM WAS ARMED. 4 = AT LEAST ONE ZONE WAS IN INFRACTION WHEN ALARM WAS
ARMED.
¢
4 = ACTIVATED / 2 = DEACTIVATED / 3 = SYSTEM NOT READY.
CONFIRMATION
In all cases, your Remote Starter will confirm that command has been received properly.
This will be done by either sounding horn or flashing parking lights. In this manual, confirmation signals are written in an
abbreviated form; for example:
(horn: 1, lights: 2) Means that horn will sound once and parking lights will flash twice.
Parking light confirmations are mandatory. Horn confirmations are optional (programmable) and require an additional
connection and equipment during installation.
Confirmations are explained in more detail under each command.