Ultra Start 1271M Automobile Alarm User Manual


 
Remote Starter Functions
Remote Starting (if remote start fails to start see page 19)
1. Press and release the button.
2. The park lights will flash and the siren* or horn (optional) will chirp once to
confirm. The vehicle will then remote start, the siren* or horn (optional) will
chirp and the park lights will then flash four times then remain on while the
vehicle is running**.
Important! If your vehicle is equipped MANUAL TRANSMISSION see your
dealer IMMEDIATELY to have the correct model installed!!!
Extended Run Time
1. While the vehicle is running with the remote starter, press and release
the button.
2. The park lights will flash and the siren* or horn (optional) will chirp one time
to confirm. The system will reset the run time**.
NOTE: Not available with 4 minute run time.
Remote Stop
1. While the vehicle is running with the remote starter, press and hold
the button for three seconds. The remote starter will shut down.
2.The park lights will flash and the siren* or horn (optional) will chirp 2 times to
confirm shutdown.
NOTE: Pressing the brake pedal or opening the hood will also shut down the
remote starter.
Idle Mode
1.While the vehicle is running with key, press and release the button.
2.The park lights will turn on and the siren* or horn (optional) will chirp twice.
3.Turn the ignition key to the “OFF” position and the vehicle will remain
running**.
Turbo Timer Mode
1. While the vehicle is running with key, press the button.
2. The park lights will turn on and the siren* or horn (optional) will chirp twice.
3. Turn the ignition key off and the vehicle will continue to run for approximately
2 minutes.
*Alarm series ONLY!
**Default 15 minutes.
OWNER’S GUIDE PAGE 6