Ultra Start 1271M Automobile Alarm User Manual


 
Timer Mode
Timer Mode will start the vehicle at a user selectable start interval. The vehicle
can be set to start once every 2, 3 or 4 hours, for a maximum of 12 starts. The
vehicle will start at the selected start interval and run for the programmed
runtime*.
EXAMPLE: If the 4 hour start cycle was selected, the vehicle will start once
every 4 hours and run for the programmed runtime*.
To Enter Timer Mode.
Method 1- Press and release the button, then press and hold the button
for 6 seconds or until park lights turn on.
Method 2 - Press the and buttons at the same time for 3 seconds or until
the park lights will turn on.
While the park lights are on the start cycle may be selected.
2 hours Press and release the button 2 Park light flashes
3 hours Press and release the button 3 Park light flashes
4 hours Press and release the button 4 Park light flashes
NOTE: Timer Mode must be set each time the user wishes to use this feature.
To Cancel Timer Mode
Method 1- Press and release the button, then press and hold the button
for 6 seconds.
Method 2- Press the and buttons at the same time for 3 seconds.
NOTE: Pressing the brake pedal or turning the ignition to the ON position will
cancel Timer Mode. Cancellation will be confirmed with 2 park light
flashes and 2 siren or horn (optional) chirps.
IMPORTANT: Never remote start or set the Timer Mode if the vehicle
is parked in a Garage or Attached Carport! (see page 4 SAFETY)
*Default 15 minutes
OWNER’S GUIDE PAGE 10