Ultra Start 1271M Automobile Alarm User Manual


 
Remote Transmitter Learn
STEP 1 - Within 3 seconds turn the ignition key to the “ON
position three times leaving “ON” the third time.
NOTE:
STEP 3a (Default) - While holding the Program Button, press and
release the button on each of the remote
transmitters to be programmed.
STEP 3b (PadLoc/ - While holding the Program Button, press and
2nd Car)* release the button on each of the remote
transmitters to be programmed.
If the parking lights do not turn “ON”, release the Program Button and
turn the ignition to the “OFF” position, wait 5sec and repeat steps 1 & 2.
STEP 2 - Press and hold the Program Button. The park lights will
turn “ON” and the siren or horn (optional) will chirp
once. Continue to hold the Program Button,
the park lights will turn “OFF” and the siren or
horn (optional) will chirp 5 times quickly.
PadLoc* is a safety feature that “LOCKS” the remote transmitter. To
UNLOCK” the remote transmitter the button must be
pressed simultaneously with the function chosen.
or
2nd Car* function allows the operation of two Ultra Start systems
(in two separate vehicles) with one remote transmitter.
Example: Press and release and simultaneously to remote start.
NOTE: Some features not available with PadLoc* or 2nd car* mode.
*12xx and 22xx series ONLY
IMPORTANT! All remote transmitters not programmed at this time
will be erased from memory for security.
PAGE 11 OWNER’S GUIDE