Filter
Top Products
Press the button VOLUME, to activate continuous fog output. The display
indicates »Volume« followed by the value that was set in menu item »Volume
Out« or »NON STOP BURST« when continuous fog output was selected. To
stop the fog output, press the button VOLUME once again.
NOTE: When a fog output volume higher then 30 % was set for continuous
operation, the fog machine occasionally needs to stop the fog output to
reheat.
When »NON STOP BURST« was selected, the fog machine adjusts the fog
output volume and heater temeperature automatically and does not need to
stop to reheat.
- Manual operation
For immediate fog output at the maximum volume of fog, keep the button
MANUAL pressed. The display indicates »Manual 100 %«. As soon as you
release the button, the fog output will stop. The manual operation will take
priority over the continuous operation and the timer operation. Even if one of
these operating modes is activated, the fog machine will always emit the
maximum volume of fog when the button MANUAL is pressed.
- Timer operation
In the timer mode, the fog machine will automatically emit fog. The time
intervals, duration and fog volume depend on the corresponding menu
settings. Press the button TIMER, to activate the timer mode. The display
indicates the set time interval. The unit counts down to 0 seconds and emits
fog. To deactivate the timer mode, press the button TIMER again.
W-1 Wireless Remote
The wireless remote control system W-1 consists of a transmitter equipped with
two buttons for fog on and off, and a receiver pre-attached to the rear panel of
each W-series model.
* Transmitter:
With the transmitter it is possible to emit fog via radio over a distance of up to
50 meters. The transmitter is compatible to any receiver of the W-series and
can control an unlimited number of machines in parallel.
-05-