Filter
Top Products
children. Never leave the unit running unattended.
Never aim the output nozzle directly at people.
Fog machine output is very hot. Avoid coming within 50 cm of the output
nozzle during operation.
Locate the fog machine in a well-ventilated area. Never cover the unit's vents.
In order to guarantee adequate ventilation, allow a free air space of at least
20 cm around the sides and top of the unit.
Never aim the output nozzle at open flames.
If the supply cord is damaged, it must be replaced by manufacturer or its
service agent or similarly qualified personnel in order to avoid a hazard.
The output nozzle becomes very hot during operation (200°C). Keep
flammable materials at least 50 cm away from the nozzle.
Always allow your ANTARI Fog Machine to cool down before attempting to
clean or service it.
Danger of Explosion
Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog
liquid.
Use only high-quality, water-based fog liquid that your dealer recommends.
Other fog liquids may cause clogging or “spitting”.
Always make sure there is sufficient liquid in the tank. Operating this unit
without liquid might cause damage to the pump as well as over-heating of the
heater.
If your ANTARI W-515 & W-530 Fog Machine fails to work properly,
discontinue use immediately. Drain all fog liquid from the tank, pack the unit
securely (preferably in the original packing material), and return it to your
ANTARI dealer for service.
Always drain tank before mailing or transporting this unit.
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid
comes in contact with skin or eyes, rinse thoroughly with water.
Note: Pay attention to all warning labels and instructions printed on the
exterior of your ANTARI Fog Machine.
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate
the system has arrived intact.
The shipping carton should contain the following items:
1. One unit of W-515 or W-530 Fog Machine
2. Power cord
3. One Set of W-1 transmitter
4. User Manual
5. Mounting brackets with washers/screws (optional for W-515)
If any equipment is missing contact your ANTARI dealer immediately.
-02-