54
Other Pattern Functions
You can modify the velocity settings for an entire track. This function
allows you to change the rate of velocity and the offset from the
recorded values.
1
Press the [PATTERN] button to put the RY20 into Pattern Mode. Select a
pattern by rotating the Jog Dial or using the [ +1 ] and [ –1 ] buttons.
2
Select Velocity display page by pressing the [PAGE+] button until the
display indicates “VELCTY” and the current rate flashes. Also notice that
one of the track “ ” indicators is lit.
3
Select the track you wish to modify with the Track Select/Mute buttons.
When you press a button, the track “ ” indicator for the current track
switches off as the indicator corresponding to the selected track lights up.
4
Alter the velocity rate by rotating the Jog Dial or using the [ +1 ] and [ –1 ]
buttons.
The default rate is “100%” which is the normal setting. The range is from
“000%” to “200%”. As you lower the rate below “100%”, all of the velocity
settings are correspondingly reduced. When you raise the rate above
“100%”, the velocity settings are correspondingly increased.
5
Change the focus to the “LEVEL” prompt using the [ > ] cursor button.
■ Velocity Modify
PAGE – PAGE +
PATTERN
A CHASE
LEVEL
MAIN A
PAD BANK
OTHERS
HH
SD
BD
OTHERS
HH
SD
BD
TRACK
SELECT/
MUTE
PATTERN
A CHASEPAD BANK
OTHERS
HH
SD
BD
