Vulcan Technology 52361 through 52372 Manual

A SERVICE OF

next previous

9

THERMOSTAT ADJUSTMENT

1. Perform calibration check as stated under Section I.

2. Remove the thermostat knob. (Fig 3)

3. Insert a flat blade screwdriver into the thermostat dial stem until it reaches the calibration screw.

4. Note the calibrated center oven average as determined under Section 1 Calibration Check. Use that number

as the calibration set point.

5. Turn the adjustment screw to the right to increase the temperature and to the left to decrease the

temperature. A

1

⁄4" turn in either direction will change the temperature by 35 degrees.

6. Perform the calibration check again and repeat the above procedure to insure that the correct center oven

average temperature has been obtained.

7. Reinstall the thermostat knob, be sure to align the knob correctly on the thermostat stem.

Fig. 3