A SERVICE OF

logo

Open as PDF
next previous
32
4. From inside the oven cavity, located behind the front frame where the door is mounted, using a
7
⁄16" socket,
remove (2) nuts holding the door assembly to the trunnion block (1) on the left door side and (1) on the right.
(Fig. 46)
Fig. 46
5. Slip the trunnion block through the mounting slot and remove the door assembly from the appliance.
6. Install new door assembly by reversing steps 1-5. After door replacement the door may require adjustment.
If adjustment is necessary refer to Section II of this manual under door adjustment.
REPLACEMENT OF TERMINAL BLOCK
1. Lower the kick panel.
2. Using a large flat head screwdriver, note and remove wiring from the terminal block connection points.
(Fig. 47)
Fig. 47
DOOR ARM
NUT
FRONT FRAME