A SERVICE OF

logo

34 Basic Operations
Startup Scenarios
If more than one person uses the 2000i, you may occasionally find that another user has turned
the unit off completely rather than placed it in standby mode. The following table describes what
you may need to do to restore the 2000i to a fully operational state.
What You See What You Should Do
Screen is black
On LED is blinking
intermittently (short
flashes between long
pauses)
The projector is in standby mode (with the lamp off).
Press the Lamp On button on the control panel. The Lamp On LED
indicator blinks quickly as the lamp warms up, and, after
approximately 60 seconds, either a blue “No Input” screen appears
(see below) or the screen is restored to its last active state.
Blue “No Input” screen
On LED is steadily
illuminated
The projector lamp is on, but the computer is either off or in standby
mode, or you’ve selected an inactive display source.
Press a key on the connected keyboard to activate the computer. The
logon screen appears.
OR
Press a source button on the control panel to change to an active
source. If the blue “No Input” screen remains, turn the computer on (or
press the computer’s reset button) and log on as usual (using the
connected keyboard).
Screen is black
On LED is blinking
slowly
No action is necessary. The projector lamp is turning on, and the
logon screen will appear after approximately 60 seconds.
Screen is black
Off LED is blinking
rapidly
The projector lamp is in reversible standby mode. If you don’t press a
button to restore the image, after three minutes the On LED indicator
will blink slowly for 60 seconds as the lamp turns off and cools down.
At this point, follow the first set of instructions in this table to restore
the 2000i to an operational state.
Logon Screen The projector lamp is still on, so you can log on as usual (using the
connected keyboard).
Lamp On LED
continues to blink
intermittently, even
though it’s been
pressed to start the
system
Projector problems are preventing a normal projector lamp warm-up.
Examine the projector status LED indicator, and then consult the
troubleshooting section of the NEC VT470/570/670 User’s Manual.
The Lamp Off and On
LEDs are both
flashing constantly
The system can’t detect a projector. Check the NEC VT470/570/670
User’s Manual to make sure the projector is connected properly.