Finalizing the Installation 27
NOTE: Perform this procedure only if the preceding procedure failed to raise or lower the image
sufficiently. This procedure will only raise or lower the image by about a 1/4" (0.6 cm).
1. Crouch behind the projector and look at the projected image through the view port.
2. Access the fine-adjustment bolt through the slot in the middle of the projector platform (shown
in the figure below).
3. Using the supplied 7/16" nut driver, turn the fine-adjustment nut to the right to raise the image,
and to the left to lower it.
NOTE: Turning this nut will only raise or lower the image by 1/4" (0.6 cm).
Configuring the Computer Settings
For optimal configuration, use these recommended settings for the computer inside the 2000i.
With these settings, you can balance ease of use while conserving energy and preserving the
projector’s lamp life.
For example, you can configure the power management and energy saving settings of your
computer so that it stops sending out a video signal and turns off the hard drive(s) after a period of
inactivity. Your projector then goes into standby mode if it doesn’t receive a video signal for 30
minutes. Even though the projector and the 2000i are in standby mode, you can press the Lamp
On button to quickly return both units to their normal operating states.
To further adjust the image up or down
CAUTION
Do not remove the fine-adjustment nut. If this nut is removed, the projector
may swing down from the platform and sustain damage.
