A SERVICE OF

logo

Open as PDF
next previous
24 Finalizing the Installation
2. Using the supplied 7/16" nut driver, loosen the two nuts located on the left side of the projector
plate.
3. Slide the projector plate to the right or left, and then tighten the two nuts.
1. Crouch behind the projector and look at the projected image through the view port.
2. Using the security key (TR20 TORX® tamper-recess key) from the accessory kit, loosen the
three TORX M4 security screws that secure the projector to the projector plate.
To change the image size
IMPORTANT
You’ll find these screws on top of the projector plate: one at the back of the
projector and two at the front. You’ll access the screws through one slot at the
back of the plate and two holes at the front, as shown in the two figures below.
Image Size Adjustment