Unit 4: Printer Configuration
CL408-412e Supplemental Manual
4-5 PN: 9001159A
DSW3 DEFAULT SETTINGS
3-1 3-2 3-3 3-4 3-5 3-6 3-7 3-8
OFF OFF OFF OFF OFF OFF OFF OFF
DSW3 CONFIGURATION
3-1
3-2
Operating Mode
3-1 3-2
OFF OFF Batch/Continuous
OFF ON Tear Off
ON OFF Cutter
ON ON Dispenser
3-3 Label Sensor
OFF Sensor Used
ON Sensor Not Used
3-4 Backfeed
OFF Enabled
ON Disabled
3-5 Print Start Signal
OFF Disabled
ON Enabled
3-6
3-7
External Signal Type
3-6 3-7
OFF OFF Type 4
OFF ON Type 3
ON OFF Type 2
ON ON Type 1
3-8 Repeat Print via Ext Signal
OFF Disabled
ON Enabled
DSW3 FUNCTION DESCRIPTIONS
FUNCTION DESCRIPTION
Operating Mode Batch/Continuous, Tear-Off, Cutter, Dispenser
Label Sensor
Enabled, detects the label’s edge and positions it automatically. Disabled, it is under
software control.
Back Feed
Enabled, positions the last printed label for dispensing and retracts the media for
printing the next.
Print Start Signal
Allows an external device to initiate a label print for synchronization with the
applicator. When on, the unit is in the Continuous print mode, Backfeed is disabled
and External Signals are ignored.
External Signal Refer to the Interface Specifications unit for information.
Repeat Print External Signal Allows an external device to repeat the print siquence.
