14
16. Connect the Air Line from the Tilt Back Tower to the
Tee Fitting located Inside the Rear of the Cabinet.
(See Fig 8.15)
17. Reinstall the Side Cover.
Bead Breaker Blade
1. Attach the Bead Breaker Blade to the Bead Breaker
Arm Assembly. Secure the Nyloc nut. (See Fig. 8.16)
Demount Head Assembly
Your machine comes with a plastic plastic demount head
installed on the machine and a metal demount head
inside the parts box.
1. Check that the Demount Head Bolt and Allen Screws
are tightened. (See Fig. 8.17)
2. To install the steel demount head you will first need to
remove the plastic demount head. To remove the plastic
demount head you will need to fully loosen the allen set
screws. (See Fig. 8.18)
3. After the set screws are loosened you will be able to
remove the plastic demount head by pulling straight down
on it.
4. Once the plastic demount head has been removed
you can place the metal demount head in place. Make
sure the top of the demount head is is pressed firmly
against the plastic hex shaft spacer and tighten both the
allen set screws and the bottom hex nut. (See Fig. 8.19)
Fig. 8.16
Fig. 8.15
Fig. 8.17
WARNING!
DO NOT operate the Tilt Tower unless the tool head
is in the LOCKED position. Damage to the machine
and/or property or persons can result if warning
not followed.
Fig. 8.18
Fig. 8.19
