A SERVICE OF

logo

Open as PDF
next previous
Preparing the Processors
2-136800-A2-GN22-30 January 1997
Preinstallation Steps for the 16 Control Channel Package
To prepare the DCP/MUXi card for installation in the System 5000 host processor, refer to
Figure 2-7 and perform the following steps:
494-14511-0
1
E
46
E
47
E 44 E45
E43
E48
E
3
8
E39
E37
E33
E32
E31
E36
E
3
5
E34
E
29
E28
E
30
E3
E1
E2
E42
E40
E
4
1
SW1
Figure 2-7. DCP/MUXi Card
1. Remove two jumpers on the card, one at position E32-E33 (interrupt request) and the other
at position E37-E38 (transparent mode interrupt). You may store a jumper for future use,
such as running diagnostics, by placing it on one pin only.
2. Verify that all other jumpers on the card are in the factory default positions.
3. Verify that the I/O address is set on the card at block SW1 as shown in Table 2-2.
Table 2-2
DCP/MUXi — I/O Address Switch Settings
SWI Description
1 2 3 4
DCP/MUXi Control Channels 9—16 on on on off