COMSPHERE 6800 Series Network Management System
4-16 January 1997 6800-A2-GN22-30
Figure 4-11. Basic-Feature Workstation Configurations
The following sections explain how to make the connections shown in Figure 4-11.
Connecting a Local Altos 486DX/33, an Altos SX/20, or an AT&T 6386 SX/EL
To connect an Altos 486DX/33, an Altos SX/20, or an AT&T 6386 SX/EL as a local basic-feature
workstation, perform the following steps:
1. Connect the grounded end of the 035-0153-0031 cable to one of the following ports on
either the host processor or the UIP:
– COM1/COM2 port: use the 002-0054-0031 connector
– IPC-1600: connect directly to port
2. Connect the other end of the 035-0153-0031 cable to the 002-0047-0031 connector.
3. Connect the 002-0047-0031 connector to the 9-pin serial connector on the basic feature
workstation.
