PagePrinter Network Adapter: Utilities & Environments 3-1
CHAPTER
Windows 95
operating
systems
3
Using Windows 95 operating systems
Introduction Thank you for buying this multi-protocol adapter. The information in this
chapter helps you install and set up your utilities to print to an adapter.
Note: You can not print from DOS.
What you need
To install the Network Adapter and start its operation, you need the following:
1 Microsoft’s Windows 95 operating system installed on your computer.
2 The MarkVision Printer Utility for Windows 95. Support for this Network
Adapter is built into the MarkVision utilities. You do not need separate
Network Printer Utilities; everything comes with MarkVision. The
MarkVision Printer Utility for Windows 95 is shipped on CD-ROM or
diskettes with many printers.
3 One of the following installed on your network:
• Be sure that the adapter is installed in the printer, and the network cable is
connected. See your printer documentation if you need help.
To check a current firmware level, contact your point of purchase
To check your firmware level, see “Step 2: print a setup page” on page
2-3.
Installing the
MarkVision printer
utility
If you already have MarkVision running under Windows 95, skip this section.
Go to "Configuring the adapter" on page 3-2.
