3 Open a Web browser, and then type the IP address of your access point in the address field.
Notes:
• The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
4 Access the WPS settings. For more information, see the documentation that came with your access point.
5 Enter the eight‑digit PIN, and then save the setting.
Connecting the scanner to a wireless network using the Embedded Web Server
Before you begin, make sure that:
• Your scanner is connected temporarily to an Ethernet network.
• A wireless network adapter is installed in your scanner and is working properly. For more information, see the
instruction sheet that came with the wireless network adapter.
1 Open a Web browser, and then type the scanner IP address in the address field.
Notes:
• View the scanner IP address on the scanner control panel. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Settings > Network/Ports > Wireless.
3 Modify the settings to match the settings of your access point (wireless router).
Note: Make sure to enter the correct SSID, security method, preshared key or passphrase, network mode, and
channel.
4 Click Submit.
5 Turn off the scanner, and then disconnect the Ethernet cable. Wait for at least five seconds, and then turn on the
scanner.
6 To verify if your scanner is connected to the network, print a network setup page. In the Network Card [x] section,
see if the status is Connected.
Changing port settings after installing a new network ISP
Notes:
• If the printer has a static IP address, then you do not need to make any changes.
• If the computers are configured to use the network name, instead of an IP address, then you do not need to
make any changes.
• If you are adding a wireless ISP to a printer previously configured for an Ethernet connection, then make sure
the printer is disconnected from the Ethernet network.
For Windows users
1
Open the printers folder.
2 From the shortcut menu of the printer with the new ISP, open the printer properties.
Additional scanner and printer setup 59
