Scenario 4: Digital telephone service through a cable provider
Setup 1: Scanner is connected directly to a cable modem
1 Connect one end of the telephone cable that came with your scanner to the port of the scanner.
2 Connect the other end of the cable to the port labeled Phone Line 1 or Phone Port on the cable modem.
Note: The port labeled Phone Line 2 or Fax Port is not always active. VoIP providers may charge additional cost
for the activation of the second phone port.
3 Connect your analog telephone to the port of the scanner.
Notes:
• To make sure that the telephone port on the cable modem is active, plug an analog telephone into the
telephone port, and then listen for a dial tone. If you hear a dial tone, then the port is active.
• If you need two telephone ports for your devices, but do not want to pay additional cost, then do not plug the
scanner into the second telephone port. You can use a phone splitter. Plug the phone splitter into the port
labeled Phone Line 1 or Phone Port, and then plug the scanner and telephone into the splitter.
• Make sure you use a phone splitter, not a line splitter. To make sure that you are using the correct splitter, plug
an analog telephone into the splitter, and then listen for a dial tone.
Faxing 127
