230
Chapter 12 Complete Command List
Defined variables are referenced in strings by placing an
$ before the
variable name (e.g.,
set model m1 trailer $FF).
set var from default
Set all variable settings back to factory defaults.
set var from stored
Set all current variable settings to the values stored in flash memory.
List Commands
These commands list the current or working settings for a particular section
within the command shell. To view stored settings in flash memory, you will
need to add in
stored within the beginning of any of the following
commands. For example,
list prn shows you the current prn settings but
list stored prn shows you the settings sitting in flash memory.
Normally these should match.
list arp
List the current ARP table that the LineJet Print Server adheres to in a
TCP/IP network.
list date
List the current date on the LineJet Print Server.
list dest
List the current destination settings (e.g., names and mapped I/O ports,
models, and logpaths).
list diff
List the differences between the current settings and the stored settings in
flash memory. Normally, you want these values to match, so issue a
save command followed by a reset.
list ifc
List the current UTP interface settings (e.g., link integrity).
list key
List the license details and license key number.
list logins
List any active user logins on the LineJet Print Server.
list logpath
List the current logpath settings (e.g., names and mapped destinations).
list model
List the current model settings (e.g., names and mapped destinations).
list pserver
List the current general print server settings (e.g., print server name and
Novell mode).
list prn
List the current parallel port setting (e.g., mode).
list rprinter
List any current RPRINTER definitions.
