166
Chapter 8 Windows Troubleshooting Tips
9. At the system prompt, enter:
store tcpip from default
config http on
save
reset
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway parameters to the
desired values.
12. If Web browser access does not work, Telnet into the LineJet Print Server
as
root. Enter the following command:
config http on
If you are still experiencing difficulty accessing or browsing the printer, contact
technical support.
Web Browser/HTTP Problem
In some cases you may not be able to browse the printer web page simply
because the LineJet Print Server HTTP may be turned off.
If you cannot
ping
the LineJet Print Server IP address, make sure the IP
Address, subnet mask, and default gateway are set correctly by checking the
Ethernet Parameters menu from the operator panel. See Chapter 4 for
configuration menu information.
If you can
ping
the LineJet Print Server IP address but cannot access the web
pages, perform the following procedure to verify the LineJet Print Server
HTTP is turned on.
1. Telnet into the Print Server and log in as
root with no password.
2. At the system prompt enter the following commands:
config http on
save
reset
3. After approximately 30 seconds, point your browser to the Print Server IP
address. The printer web pages should now be accessible.
If you are still experiencing difficulty accessing or browsing the printer, contact
technical support.
Note This will reset all TCP/IP settings to factory default and reset the LineJet
Print Server.
