All the text is printed on the same line.
Cause What to do
No line feed command is sent
at the end of each line of text.
Make sure that auto line feed is set to
ON using DIP switch 3-3 so that the
printer automatically adds a line-feed
code to each carriage return. See
“Using DIP Switchs” in Chapter 4.
The text is printed with extra blank lines between lines of text.
Cause What to do
Two line feed commands are
being sent at the end of each
line of text.
Make sure that auto line feed is set to
OFF using DIP switch 3-3.
The line-space setting in your
application software is wrong.
Adjust the line-space setting with your
application software.
Page length does not match the length of paper being used.
Cause What to do
The page size setting in your
application or the printer
driver may not match the size
of paper you are using.
Check the paper size setting in your
application or printer driver.
Page length for tractor may
be set incorrectly using the
DIP switches.
Change DIP switch 2 to select the
correct page length for the tractor. See
“Using DIP Switches” in Chapter 4.
8
Troubleshooting
R
Peony Rev.C
A5 size Chapter 8
98/01/07 DR, pass 4
Troubleshooting 8-17
