A SERVICE OF

logo

Mobile Base Installation Guide
CHAPTER 1
Eddy Current Brake
1-14
COUPLING THE EDDY CURRENT BRAKE
Coupler alignment is very important. You must follow these directions very
carefully to ensure proper alignment and function. Dynojet will not warranty
any coupler that is damaged due to improper installation.
1 Slide the dyno coupler over the eddy current brake coupler so the three holes in
each of the couplers line up.
2 Secure the couplers together using three 3/8-inch bolts removed earlier and
tighten to 33-37 ft. lb. (45-50 N-m).
3 Verify the key has not moved laterally.
4 Tighten the set screws in the couplers to 24 ft. lb. (29-33 N-m).
Figure 1-20: Secure the Couplers
set screws
bolts