A SERVICE OF

logo

Mobile Base Installation Guide
CHAPTER 1
Installation
1-8
MOVING THE BRAKE TO THE MOBILE BASE FRAME
1 Using a fork lift and nylon loop straps, move the eddy current brake onto the
mobile base frame.
Figure 1-9: Place the Brake on the Mobile Base Frame
2 Slide the brake up to the dyno.
3 Loosen the bolts on the brake connecting arms to allow the arms to move. There
are four bolts on each arm.
4 Line up the connecting arms with the dyno and loosely attach the arms to the
dyno using the bolts and washers you removed earlier. These bolts need to
remain loose in order to align the brake.
5 Tighten the bolts securing the connecting arms to the brake.
Figure 1-10: Attach the Brake to the Dyno
bolts on
dyno side
connecting arm
bolts on
brake side
coupler