A SERVICE OF

logo

PowerConnect B-Series FCX Configuration Guide 631
53-1002266-01
Enabling or disabling layer 2 switching
19
Syntax: no route-only
To disable Layer 2 switching only on a specific interface, go to the Interface configuration level for
that interface, then disable the feature. The following commands show how to disable Layer 2
switching on port 2.
PowerConnect(config)#interface ethernet 2
PowerConnect(config-if-e1000-2)#route-only
Syntax: route-only
To re-enable Layer 2 switching, enter the command with “no”, as in the following example.
PowerConnect(config-if-e1000-2)#no route-only