A SERVICE OF

logo

412 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Dynamic link aggregation
12
FIGURE 82 Examples of valid aggregate links
In this example, assume that link aggregation is enabled on all of the links between the Dell
PowerConnect device on the left and the device on the right (which can be either a Dell
PowerConnect device or another vendor device). The ports that are members of aggregate links in
this example are following the configuration rules for trunk links on Dell PowerConnect devices.
The Dell rules apply to a Dell PowerConnect device even if the device at the other end is from
another vendor and uses different rules. Refer to “Trunk group rules” on page 395.
Configuration notes and limitations
This section lists the configuration considerations and limitations for dynamic link aggregation.
Port1/1
Port1/2
Port1/3
Port1/4
Port1/5
Port1/6
Port1/7
Port1/8
Port1/1
Port1/2
Port1/3
Port1/4
Port1/5
Port1/6
Port1/7
Port1/8
Port1/1
Port1/2
Port1/3
Port1/4
Port1/5
Port1/6
Port1/7
Port1/8
Ports enabled for link
aggregation follow the same rules
as ports configured for trunk groups.