486 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Configuring 802.1Q-in-Q tagging
13
PowerConnect(config)# tag-type 9100 ethernet 11 to 12
PowerConnect(config)# aggregated-vlan
Note that because ports 11 and 12 belong to the port region 1 – 12, the 802.1Q tag actually
applies to ports 1 – 12.
Syntax: [no] tag-type <num> [ethernet <port> [to <port>]]
Specify the <port> variable in the following formats:
• PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
The ethernet <port> to <port> parameter specifies the ports that will use the defined 802.1Q tag.
This parameter operates with the following rules:
• If you specify a single port number, the 802.1Q tag applies to all ports within the port region.
For example, if you enter the command tag-type 9100 ethernet 1, the Dell PowerConnect
device automatically applies the 802.1Q tag to ports 1 – 12 because all of these ports are in
the same port region. You can use the show running-config command to view how the
command has been applied.
• If you do not specify a port or range of ports, the 802.1Q tag applies to all Ethernet ports on the
device.
