A SERVICE OF

logo

Figure 66. Cabling diagram—3.5 inch (x8) SAS/SATA backplane (option 2)
1. hard drive backplane 2. backplane signal connector 1
3. system board 4. SAS A connector on the system board
5. SAS B connector on the system board
Next steps
1. Replace the hard drive backplane. See Installing the hard drive backplane .
2. Follow the procedure listed in After working inside your system.
Installing the hard drive backplane
Prerequisites
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
136