Related
Commands
diag — run diagnostic tests on an offline switch.
online stack-unit— reload the system after running offline diagnostic tests.
online system
Reload a switch after running offline diagnostic tests.
Z9500
Syntax
online system
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
Usage
Information
This command is used to manually reset or reboot the system when diagnostics
complete.
Related
Commands
diag — run diagnostic tests on an offline switch.
offline stack-unit— bring the system offline to run diagnostic tests.
show diag
Display results of offline diagnostic tests on a switch.
Syntax
show diag {all | {{cp | rp | linecard} unit-id} [summary |
detail]
Parameters
all Enter the keyword all to display the results of offline
diagnostic tests on all Z9500 CPUs, including the Control
Processor, Route Processor, and line cards.
652
Debugging and Diagnostics
