Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.4.1.0 Introduced
Usage
Information
The system must have the default CAM profile with the default microcode before
you enable L2PT.
protocol-tunnel rate-limit
Enable traffic rate limiting per box.
Z9500
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit
rate command.
Parameters
rate Enter the rate in frames per second. The range is from 75 to
3000. The default is 75.
Defaults 75 frames per second.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1688
Service Provider Bridging
