Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale, C-Series, and S-
Series.
Usage
Information
By default, all prefixes configured as addresses on the interface are advertised. This
command allows control over the individual parameters per prefix; you can use the
default keyword to use the default parameters for all prefixes. If a prefix has been
configured with lifetime parameter values, the default values cannot be applied
using the ipv6 nd prefix default no-autoconfig command.
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
Z9500
Syntax
ipv6 neighbor {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor {
ipv6-address} {interface interface} command.
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
interface
interface
Enter the keyword interface then the interface type and
slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
hardware_addr
ess
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn
format.
IPv6 Basics
1023
