• temperature
For the snmp notification-type, enter one of the following
optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Defaults Not enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.1(0.0) Added support for copy-config and ecmp traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-
Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
The system supports up to 16 SNMP trap receivers.
For the cam-utilization notification option, the system generates syslogs and
SNMP traps when the L3 host table or route table utilization goes above the
threshold.
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
Related
Commands
snmp-server community — enables SNMP and sets the community string.
snmp-server host — configures an SNMP trap receiver.
1714
Simple Network Management Protocol (SNMP) and Syslog
