849 | DellPowerConnectW-SeriesArubaOS6.2 | User Guide
5. Click Ok to save your settings.
Configure the Controller to use IAS Management Authentication
The following procedure describes the steps to configure the controller to user IAS management authentication.
1. Access the controller WebUI and navigate to Configuration>Authentication.
2. Select the Servers tab.
3. Select RADIUS Server.
4. Enter a name for the RADIUS server in the entry field in the right window pane, then click Add.
5. Select the RADIUS server you just created from the list of servers in the left window pane to display
configuration details for that server.
Figure 414: Configuring a RADIUS Server for IAS Management Authentication
6. In the Host field, enter the IP address of the RADIUS server you want to use for Management Authentication.
7. Enter and then retype the shared key for the server.
8. Click Apply
9. Select Server Group from the server list on the left window pane.
10. In the entry blank on the right window pane, enter the name of a new server group (for example, “Management_
group”), then click Add.
11. Click Apply.
12. Select the server group you just created from the list of server groups in the left window pane.
13. In the Servers section, click New.
14. Click the Server Name drop-down list and select your RADIUS server.
Figure 415: Configuring a Server Group for IAS Management Authentication
