A SERVICE OF

logo

Open as PDF
next previous
P-99
QT-2100 Programming Manual
4-2-5-6 Programming function control 3 by range
Operation
5. Select “6. Allowed function 3” and press the <YES> key.
6. Select an appropriate record and press the <YES>/<NO>
key.
7. After programming, press the <ESC> key to proceed to the
next step.
8. Enter the start range No. and press the <YES> key.
(It starts “0001” if you skip to enter the start range.)
Then enter the end range No. and press the <YES> key.
(It ends the last record if you skip to enter the end range.)
9. Press the <YES> key.
10. Press the <ESC> key to return to the previous menu.
Allowed function 3
Operator X/Z YES
Tray Total YES
Subtotal YES
Receipt on/off YES
TAST YES
Operator Number YES
MDST YES
X YES
X/For YES
X/XX YES
X/XXX YESv
0.00
Allowed function 3
X/XX YES^
X/XXX YES
Ketten Bon YES
Selective Item ST YES
New Check YES
Old Check YES
New/Old Check YES
Add Check YES
Separate Check YES
Clock-in/out YES
Break-in/out YES
0.00
Range
Operation
1.Clerk Control
2.Menu Shift/2nd@
3.Mode Control
4.Allowed function 1
5.Allowed function 2
6.Allowed function 3
7.Allowed function 4
8.Allowed function 5 v
0.00
Allowed function 3
Enter Start range 0
End range 0
OK? YES
0.00
Allowed function 3
Enter Start range 1
End range 123
OK? YES
0.00