SERVSELECT™ IP INSTALLER/USER GUIDE
32
CHAPTER 4: ANALOG PORT OPERATION
33
Figure 4-16. Scan Dialog Box
3. Determine the order within the list to add the server. If there are no servers in the
scan list, your cursor will appear in a blank line at the top of the list.
-or-
To add a server to the end of the list, place your cursor in the last server entry
and press the Down Arrow key.
-or-
To add a server in the midst of an existing list, place your cursor at the entry
below where you want to insert a new server and press Insert.
4. Type the rst few characters of a server name or port number to scan. The rst
matching server will appear in the line.
-or-
To move through the list, press the following keyboard commands in the Name, Port
or Sec column to move through the list of servers available to scan.
a. Press Alt+Down Arrow to move the cursor down through the list of servers.
b. Press Alt+Up Arrow to move the cursor up through the list of servers.
c. Press Alt+Home to move the cursor to the rst server in the list.
d. Press Alt+End to move the cursor to the last server in the list.
5. In the Sec column, type the number of seconds (from 3 to 255) of desired time
before the scan moves to the next server in the sequence.
6. Move the cursor to the next line or press the Down Arrow and repeat steps 2-5 for
each of the remaining servers to be included in the scan pattern.
7. Click OK.
To remove a server from the scan list:
1. In the Scan dialog box, click the server to be removed.
2. Press Delete.
-or-
Press Shift+Delete to remove the selected server and all entries below it.
3. Click OK.
