Filter
Top Products
CHARGING
TO CHARGE ZAPPY'S BATTERY (FIG.7)
1.
Plug the charger power
connector into the battery
charging jack.
2.
Then, plug the ZAP
charger into a standard
110 VAC (or 220, if applic-
able) wall socket.
3.
Please observe all safety
warnings described on
pages 14-16.
NEVER EXPOSE THE CHARGER TO WET OR DAMP CONDITIONS!
NOTE: You can charge the battery away from ZAPPY. Remove
the deck, disconnect the battery power connector, and remove the
battery. Connect the charger power connector to the power
connector on the battery.
TO DISCONNECT THE CHARGER:
1.
First, unplug the ZAP charger from the 110 VAC (or 220 in some
countries outside the USA) wall socket.
2.
Then, disconnect the charger power connector from the battery
charging connector.
3.
Replace the battery charger back under the deck.
4.
Reattach the deck.
NOTE: Your ZAPPY is equipped with a low voltage cutout. This
means that when your battery is discharged, the controller will
shut off the motor. If this happens, you must recharge ZAPPY
immediately to avoid damaging your battery permanently.
CHARGING TIME
•
The battery will usually take up to several hours to fully recharge.
Refer to the charger instructions included with your ZAPPY
to determine when your battery is completely charged.
•
Charge the battery immediately after use in order to maximize bat-
tery life. Charge the battery at room temperature if possible. Use
only the ZAP battery charger. Using any other charger may dam-
age the battery.
CHARGE BATTERY AFTER EVERY USE!
10
Fig.7