Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
4-16
4
EAU12711
Start switch “”
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
EAU41700
The engine trouble warning light will
come on when the key is turned to “ON”
and the start switch is pushed, but this
does not indicate a malfunction.
EAU47494
Drive mode switch “MODE”
WARNING
EWA15340
Do not change the D-mode while the
vehicle is moving.
Using this switch changes the drive
mode to “STD”, “A”, or “B” in the follow-
ing order:
STD → A → B → STD
The throttle grip must be completely
closed in order to change the drive
mode. (See page 4-1 for an explana-
tion of each drive mode.)
TIP
● The mode is set to “STD” by de-
fault. The “STD” mode resets
when the key is turned to “OFF”.
● The selected mode is shown on
the drive mode display. (See page
4-11.)
EAU12820
Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
4-30.)
1. Clutch lever
U14B10E0.book Page 16 Friday, November 21, 2008 9:38 AM