Filter
Top Products
8-31
EVU00810
Idle speed adjustment
NOTE:
_
A diagnostic tachometer must be used for this
procedure.
_
1. Start the engine and warm it up for a few
minutes at approximately 1,000 to
2,000 r/min. Occasionally rev the engine
to 4,000 to 5,000 r/min. The engine is
warm when it quickly responds to the
throttle.
2. Remove the seats. (See page 4-20 for
seat removal and installation procedures.)
3. Remove the console. (See page 8-8 for
console removal and installation proce-
dures.)
4. Connect the tachometer to the spark plug
lead, and then set the idle to the specified
idling speed by adjusting the throttle stop
screw. Turn the screw in direction
a
to
increase the engine speed, and in direc-
tion
b
to decrease the engine speed.
1. Throttle stop screw
5. Install the console.
6. Install the seats.
EVU00820
Valve clearance adjustment
The correct valve clearance changes with
use, resulting in improper fuel/air supply or
engine noise. To prevent this, the valve clear-
ance must be adjusted regularly. This adjust-
ment however, should be left to a professional
Yamaha service technician.
Specified idle speed:
1,450–1,550 r/min
U5UG12.book Page 31 Thursday, June 23, 2005 9:02 AM