Filter
Top Products
7-1
ESU00112
7-
OPERATION
ESU00281
Starting the engine
WARNING
@
●
Be sure to check the “SAFETY INFORMATION”
section carefully before starting the engine.
●
Make sure that the parking brake is applied.
@
NOTE:
@
Make sure that the engine stop switch is in the on posi-
tion.
@
1. Fully open the starter lever (choke).
1
Starter lever (choke)
2
Fully open (cold engine starting)
3
Half-open (warm engine up)
4
Closed (warm engine starting)
NOTE:
@
The starter lever (choke) is not required when the engine
is warm. Put the starter lever (choke) in the closed posi-
tion.
@
Manual starting model
For MM600 / SX600
2. Turn the main switch to the “ON” position.
1
“ON”
3. Pull slowly on the recoil starter until it is engaged,
then pull it briskly. After the engine starts, put the
starter lever (choke) in the half-open position. Warm
up the engine until it does not run roughly or begin to
stall when the starter lever (choke) is returned to the
closed position.
E_8DG.book Page 1 Friday, June 29, 2001 4:20 PM