Filter
Top Products
5-6
ESU00031
Engine stop switch
The engine stop switch
1
is used to stop the engine in
an emergency. Simply push
2
the stop switch to stop the
engine. To start the engine, pull
3
the stop switch and
proceed with starting the engine. (See page 7-1 for more
details.)
During the first few rides, practice using the stop switch
so that you can react quickly in an emergency.
ESU00241
Brake lever
The snowmobile is stopped by braking the entire drive
system.
Squeeze the brake lever towards the handlebar grip to
stop the snowmobile.
1
Brake lever
2
Brake lever end
3
Handlebar end
NOTE:
@
When the brake lever is operated, the brake light will illu-
minate.
@
CAUTION
:
@
Make sure that the brake lever end does not project
out over the handlebar end. This will help prevent
brake lever damage when the snowmobile is placed
on its side for service.
@
For SX600 / VT600 / VX600ER
The brake lever is equipped with a position adjuster.
To adjust the brake lever position:
1. Loosen the locknut
1
.
2. While lightly pushing the brake lever in direction
a
,
finger tighten the adjusting bolt
2
to set the brake
lever to the desired position.
3. Tighten the locknut securely after adjusting the brake
lever.
E_8DG.book Page 6 Friday, June 29, 2001 4:20 PM