Filter
Top Products
8-28
3. Move the handlebar up or down (
±
7°) to adjust the
handlebar height to the desired position.
È
MM600
É
SX600
CAUTION
:
@
Make sure that the projection on the handlebar is not
installed into the area a shown.
@
4. Tighten the handlebar bolts and install the handlebar
cover.
CAUTION
:
@
Make sure that the small gap b side of the handlebar
holders faces forward c.
@
A
B
Handlebar bolt tightening torque:
23 Nm (2.3 m·kgf, 17 ft·lb)
E_8DG.book Page 28 Friday, June 29, 2001 4:20 PM