Filter
Top Products
Periodic maintenance and adjustment
65
5. Lift up the rear of the top cover, discon-
nect the main switch coupler, and then
remove the cover.
To install the top cover
1. Connect the main switch coupler.
2. Place the top cover in the original posi-
tion, making sure to fit the projections on
the cover into the slots in the headlight
unit.
3. Tighten the quick fastener screws.
4. Pass the brake hose, throttle cable, park-
ing brake cable and wire harness through
the cable guide, place the cable guide in
the original position, and then install the
screws.
5. Connect the auxiliary DC jack coupler,
and then fasten the auxiliary DC jack lead
with the plastic band.
6. Install the left side cover and the shroud.
NOTICE
ECS00372
● Make sure that all cables, hoses and
leads are routed properly before install-
ing the shroud and covers.
● When installing the shroud and covers,
be sure to tighten the fasteners secure-
ly.
1. Quick fastener screw
2. Top cover
1. Top cover
2. Main switch coupler
2
1
1. Top cover
1. Cable guide
1
1
U8JA11E0.book Page 65 Monday, June 14, 2010 10:22 AM