Filter
Top Products
Control functions
25
ESU13264
Helmet shield heater jack
(RS90GT / RS90LTGT /
RST90GT)
The helmet shield heater jack is located on
the left side of the handlebar.
TIP
The helmet shield heater jack can only be
used if the engine is running.
To use the helmet shield heater jack
1. Start the engine.
2. Open the helmet shield heater jack cap,
and then insert the power plug of the hel-
met shield heater into the jack.
3. After using the helmet shield heater, be
sure to remove its power plug from the
jack and to close the jack cap.
NOTICE
ECS00892
To avoid circuit overload and a possible
fuse blowing, do not use a helmet shield
heater requiring more than the maximum
rated capacity for the helmet shield heater
jack. (See page 109 for the specified fuse
amperage.)
ESU10571
Brake lever
The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
TIP
When the brake lever is squeezed, the brake
light comes on.
NOTICE
ECS00060
Make sure that the brake lever end does
not project out over the handlebar end.
This will help prevent brake lever damage
when the snowmobile is placed on its side
for service.
RS90GT / RS90LTGT
The brake lever is equipped with a position
adjuster.
To adjust the brake lever position:
1. Loosen the locknut.
2. While lightly pushing the brake lever in di-
rection (a), turn the adjusting bolt to set
the brake lever to the desired position.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
1. Helmet shield heater jack cap
2. Helmet shield heater jack
1
2
Maximum rated capacity:
DC 12 V, 1.5 A (18 W)
1. Brake lever
U8JA11E0.book Page 25 Monday, June 14, 2010 10:22 AM