Filter
Top Products
Control functions
14
ESU10531
Engine stop switch “”
The engine stop switch is used to stop the en-
gine in an emergency. Simply push the stop
switch to stop the engine. To start the engine,
pull the stop switch and proceed with starting
the engine. (See page 32 for engine starting
procedures.)
During the first few rides, practice using the
stop switch so that you can react quickly in an
emergency.
ESU10661
Headlight beam switch
“LIGHTS”
Push the headlight beam switch to change the
headlight to high beam “HI” or to low beam
“LO”.
ESU10674
Grip/thumb warmer adjustment
switch
The grip/thumb warmer adjustment switch
controls the electrically heated handlebar
grips and throttle lever.
To raise the temperature
To raise the grip warmer temperature, press
the “” side of the switch. To raise the thumb
warmer temperature, press the “” side of
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
See “Fuel meter and grip/thumb warmer level
indicator” on page 11 for detailed information.
1. Warning light “”
2. Self-diagnosis warning indicator “”
3. Two-digit error code
1. Engine stop switch “”
1. Headlight beam switch “LIGHTS”
2. High beam “HI”
3. Low beam “LO”
1. Grip/thumb warmer adjustment switch
U8HK10E0.book Page 14 Tuesday, June 10, 2008 1:58 PM