Filter
Top Products
8-13
8
To install the panel
1. Place the panel in the original position, and
then install the quick fastener screws.
2. Place the carrier in the original position, and
then install the carrier bolts under the fenders.
3. Install the carrier top bolts, and then tighten all
bolts to the specified torques.
Panel E
To remove the panel
Remove the bolts, and then take the panel off.
To install the panel
Place the panel in the original position and install
the bolts.
Panel F
To remove the panel
Pull outward on the areas shown.
1. Quick fastener screw
2. Panel C
Tightening torques:
Carrier bolt (top):
34 Nm (3.4 m·kgf, 24 ft·lbf)
Carrier bolt (under fenders):
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
1. Panel E
2. Bolt
U1P113E0.book Page 13 Friday, May 19, 2006 9:10 AM