Filter
Top Products
Speed Radar Audio/V
isual Alerts
W
hen X, K, or Ka band is detected, the band ID
a
nd signal strength are displayed. The audio
alert is continuous and has a geiger counter-like
p
attern. The faster the beep, the closer or
s
tronger the radar source.
“
I
I
” = weak signal, “
I
I
I
I
I
I
” = strong signal
“
K
K
/
/
K
K
a
a
” Icon will flash for
K
K
a
a
detection
Laser Audio/Visual Alerts
When a laser signal is detected, the “
V
V
/
/
L
L
” will
be illuminated.
Pulse Protection
®
Pulse (instant-on) radar is more difficult to
detect than conventional radar because it
remains off until activated to measure the speed
of a targeted vehicle.
When a pulse type transmission is detected, your
Whistler detector sounds an urgent 3-second
audio warning and the display will show a max
signal strength level.
M
M
a
a
x
x
S
S
i
i
g
g
n
n
a
a
l
l
After the 3-second pulse alert, the standard alert
pattern continues for as long as the signal is
present.
It is important to respond promptly to a pulse
alert, since warning time may be minimal.
LASER/RADAR ALERTS
Aler
t Priority
W
hen two or more signals are received at the
s
ame time, the alert priority is:
1. Laser
2
.
V
G-2
3
.
S
peed Radar
4. Safety Radar
E
xample:
I
f X band is alerting, then suddenly a VG-2
s
ignal is detected, the VG-2 warning will
o
verride the X band alert.
POP
™
MODE ALERTS
POP™ Mode Alerts
Because POP
™
Mode radar utilizes the same
K or Ka band frequencies, POP
™
Mode Alerts will be
displayed as regular radar alerts.
ALERT PRIORITY
Reset Featur
es
A
ll user features can be reset to factory settings.
•
Unplug Power Cord from unit.
• Remove Batteries.
•
Press and hold Power and Quiet buttons.
•
Plug Power Cord into unit.
• Wait for 2 beeps.
• R
elease Power and Quiet buttons.
Unit is now re
set to the following features
a
nd settings.
Default factory settings are:
1.
Audio to level (4)
2. Display shows “
H
H
”
3. Auto Quiet Mode OFF
4. VG-2 Detection Mode OFF
5. Auto Shut Off to 1 hour
6. Full Power Up sequence
7. Dim/Dark to full Illumination
8. Periscopes to Flashing
TROUBLESHOOTING
Your Whistler detector is expertly engineered
and designed to exacting quality standards to
provide you with reliable, trouble-free operation.
If your unit has been correctly installed following
the guidelines in this manual, but is not
operating optimally, please refer to the
troubleshooting guide below.
PROBLEM: No display or audio.
• Make sure batteries are installed with the
correct polarity.
• Make sure batteries are fully charged.
• Make sure battery contacts are clean.
• Check fuse in Whistler plug; replace if
necessary with a 2 amp 3AG type.
RESET FEATURES
14
15
16