Filter
Top Products
POP™ Mode Alerts
Because POP
™
Mode travels on regular radar
bandwidth, there is no particular alert for POP
™
Mode transmissions. POP
™
Mode alerts will be
displayed as a regular radar alert.
LASER/RADAR ALERTS
Speed Radar Audio/Visual Alerts
When X, K or Ka is detected, the band ID and
signal strength is displayed. The audio alert is
continuous and has a geiger counter-like
pattern. The faster the beep, the closer or
stronger the radar source.
Laser Audio/Visual Alerts
When a laser signal is detected the audio alert is
continuousfor a minimum of 3 seconds.
• The unit shows
an “L”.
Pulse Protection
®
Pulse (or instant-on) radar is more difficult to
detect than conventional radar because it
remains ‘off’ until activated to measure the speed
of a targeted vehicle.
When a pulse type transmission is detected, your
Whistlerdetector sounds an urgent 3-second
audio warning and the unit displays a “P”.
After the 3-second pulse alert, the standard alert
pattern continues for as long as the signal is
present.
It is important to respond promptly to a pulse
alert, since warning time may be minimal.
POP MODE ALERTS
VG-2 Audio/Visual Alerts
Note: You must turn this feature on before it will
detect VG-2.
When a VG-2 signal is detected, the detector ‘hides’ its
o
wn radiated signal and becomes undetectable by
the VG-2.
Every 30 seconds, the detector checks for a VG-2
signal. If a VG-2 signal is still present, the unit
continues to hide and repeats the VG-2 alert. If no
signal is detected, two beeps are provided,
indicating an ‘all clear’ condition. During a VG-2
Alert X, K, and Ka band signals cannot be
received (Reference page 21 for VG-2 information).
Alert Priority
When two or more signals are received at the
same time, the alert priority is:
1. Laser
2. VG-2
3. Speed Radar
4. Safety Radar
Example:
If X band is alerting, then suddenly a VG-2
signal is detected, the VG-2 warning will
override the X band alert.
VG-2 ALERTS
Reset Features
All user features can be reset to factory settings.
• Unplug Power Cord from unit.
• Press and hold Power and Quiet.
• Plug Power Cord into unit.
• Wait for 2 beeps.
• Release Power and Quiet buttons.
Unit is now reset to the following features
and settings.
Default factory settings ar
e:
1. Audio to level (4).
2. Display shows “H”
3. Auto Quiet Mode OFF.
4. VG-2 Detection Mode OFF.
5. Safety Radar OFF. (Pro-68 only)
6. Dim/Dark Mode to full illumination.
7. All Radar Bands ON. (Pro-68 only)
8. LED Periscope to Blink. (Pro-68 only)
9. POP ON.
10. Display at full illumination
TROUBLESHOOTING
Your Whistler detector is expertly engineered
and designed to exacting quality standards to
provide you with reliable, trouble-free operation.
If your unit has been correctly installed following
the guidelines in this manual, but is not
operating optimally, please refer to the
troubleshooting guide below.
PROBLEM: No display or audio.
• Check fuse in Whistler plug; replace if
necessary with a 2 amp 3AG type.
• Check fuse for lighter socket; replace if
necessary.
• Make sure lighter socket is clean.
RESET FEATURES
14 15
16