Filter
Top Products
Engaging/Disengaging VG-2
P
P
r
r
o
o
-
-
5
5
8
8
:
:
Press and hold the quiet button. Unit
beeps once for VG-2 on, twice for of
f.
P
P
r
r
o
o
-
-
6
6
8
8
:
:
See Option Mode to engage VG-2.
When a VG-2 signal is detected, the VG-2 alert
is sounded. After 3 seconds the audio is can-
celled and the VG-2 indicator flashes at a slower
rate. This cycle is repeated if the VG-2 signal is
again detected. During the period a VG-2 signal
is detected, a radar signal cannot be detected.
However
, because the VG-2 alert has confirmed
that a patrol car is nearby, you are already aware
of the potential for speed monitoring and can
adjust your speed accordingly. Laser detection is
not affected while a VG-2 signal is detected.
Vehicle Battery Saver Mode
The Vehicle Battery Saver Mode automatically
shuts off your detector within 3 hours if you for-
get to turn it off. The timer is reset if the detec-
tor is turned off, unplugged or any button is
pressed before the 6 hours have expired. The
detector will alert you with an audible and visual
warning before it shuts off.
During this warning you can reset the timer by
pressing any button.
If the unit has automatically turned itself off,
press the Power button to turn the unit back on.
You can manually engage the Vehicle Battery
Saver Mode by pressing and holding the City
button until one beep is heard.
OPERATION OPERATION
Option Select Mode (Pro-68 only)
Press the Menu button to enter Option Select
Mode. Each press of the Menu button changes
to the next selectable feature.
The Dark (
D
D
) button and the Quiet (
Q
Q
) button
turns the featur
e ON/OFF or Blinking. The deci-
mal point illumination indicates whether a fea-
ture is on or off. A button must be pressed with-
in 20 seconds or Option Select Mode will auto-
matically be exited.
Feature: Option:
Option Select Mode (Pro-58 only)
Press the Quiet/Menu button to enter Option
Select Mode. Each press of the Menu button
changes to the next selectable feature.
Feature: Option:
11 12 13
OPERATION
SWS
Safety Warning System™
In communities where transmitters are located,
the Safety Warning System
™
displays over 60
text messages. When Safety Radar is detected
the audio alert is geiger counter-like and dis-
plays a to indicate a SWS
™
message has been
received.
Note: Not all areas have Safety Warning System
™
transmitters.
Filter Mode (Pro-68 only)
There are times when a radar detector can emit
the same frequency as police radar and can
cause your detector to falsely alarm. Sometimes
a detector can display a signal when picking up
another radar detector in vehicle close by. The
Whistler Filter Mode option provide a method
to study the signal which will verify if the signal
is a legitimate police radar or a false alert from
another detector.
Filter: Allows for normal filtering.
Filter is the factory default and should provide
adequate filtering for most conditions. Filter
Mode does not override Highway or City set-
tings. See Option Select Mode to change Filter
settings.
VG-2 (default = OFF)
DD
for ON,
QQ
for OFF
Twin Alert Periscope
(default = Blinking with alert)
DD
or
QQ
for ON, OFF,
BLINKING
X Band (default = ON)
DD
for ON,
QQ
for OFF
K Band (default = ON)
DD
for ON,
QQ
for OFF
Ka Band (default = ON)
DD
for ON,
QQ
for OFF
POP Mode (default = ON)
DD
for ON,
QQ
for OFF
SWS (default = OFF)
DD
for ON,
QQ
for OFF
Filter (default = ON)
DD
for ON,
QQ
for OFF
VG-2 (default = OFF) Press and hold
QQuuiieett
“V” Indicates its on
POP Mode (default = ON) Press and hold both
VVoolluummee
BBuuttttoonnss
“P” indiactes POP ON