Filter
Top Products
2000 Volvo S & V70
2. Hold the end of your hand-held transmitter 2 to 5 in. (5 to 12 cm) away from the HomeLink® surface,
keeping the indicator light in view. For placement questions, please contact HomeLink® at
1-800-355-3515 (Internet: www.HomeLink.jci.com).
3. Using both hands, simultaneously push the hand-held transmitter button and the HomeLink® button
to be programmed. Do not release the buttons until this step has been completed.
The HomeLink® indicator light will begin to flash, first slowly, then rapidly. When the indicator light
flashes rapidly (indicating that the HomeLink® button has been successfully programmed), both buttons
may be released.
The remaining two HomeLink® buttons can be programmed in the same way.
If, after several attempts, you do not successfully program the HomeLink® Universal Transceiver to
learn the signal of the hand-held transmitter, refer to the section "Programming rolling codes" or call the
toll-free customer assistance number: 1-800-355-3515 (Internet:
www.HomeLink.jci.com).
WARNING!
· If you use the HomeLink® Universal Transceiver to open a garage door or gate, be sure that no one
is near the gate or door while it is in motion.
· Do not use the HomeLink® Universal Transceiver with any garage door opener that lacks safety
"stop" and "reverse" features as required by federal safety standards. (This includes any garage door
opener model manufactured before April 1, 1982). A garage door opener which cannot "detect" an
object, signalling the door to "stop" and "reverse" does not meet current federal safety standards.
Using a garage door opener without these features increases the risk of serious injury or death. For
more information on this matter, call toll-free 1-800-355-3515 (Internet:
www.HomeLink.jci.com).
pg. 199 HomeLink® Universal Transceiver (option)
NOTE - Canadian residents:
During programming, your hand-held transmitter may automatically stop transmitting. To train your
hand-held transmitter, continue to hold the HomeLink® button (see steps 2, 3 under "Programming the
transceiver") while you press and repress ("cycle") your hand-held transmitter button every two seconds
until the frequency signal has been learned. The HomeLink® indicator light will flash slowly and then
rapidly to indicate that the HomeLink® button has been successfully programmed.
Programming rolling codes
file:///K|/ownersdocs/2000/2000_SV70/00sv70_11.htm (2 of 5)12/30/2006 3:43:56 PM